INSTALLING FIXED CAMERA BRACKET (ALL MODELS) |
|
1. Loosen the two pan adjustment screws and rotate the bracket to | NOTE: A 90˚ BNC connector is included in the |
the desired viewing location. | packet to assist in fitting the camera (Figure 6). |
Pan adjustment screw
Pan adjustment screw
Figure 6
Figure 3
2.Tilt and height adjustments can be made using the two screws located on the upper portion of the fixed camera bracket. Loosen- ing the screws allows the bracket itself to slide up and down the bracket arms (height adjustment) and back and forth on the cam- era bracket (tilt). Adjust to the desired location (Figure 4).
Figure 4
4.Attach the camera to the bracket using the
IMPORTANT NOTE: Put the dome in place to assure the camera does not touch it. To reattach the dome you must twist it, if the dome comes in contact with the camera its position could change.
Tilt adjustment screw
Figure 7
3.The camera can also be adjusted back and forth via the slot located on the bottom of the bracket (Figure 5).
Figure 5
- -