Panasonic PT-60LC13, PT-50LC13 Accessories, Remote Control Battery Installation, Before Using

Before Using

Accessories

1. Remote Control (EUR7603ZB0)

2.Batteries 2 “AA”

3.RGB Cable (2 m) (LSJA0239-1 or LSJA0443)

4. DVI Cable (2 m) (K1HA24DA0003)

Remote Control Battery Installation

Requires two AA batteries (supplied).
1. Turn the Transmitter face down.	2. Install the batteries as shown in	3. Replace the cover and slide
Remove top cover by pressing	the battery compartment.	in reverse until the lock
down on marking and sliding	(Polarity + or - must match the	snaps.
cover off in the direction indicated.	markings in the compartment).

Two AA size

CAUTION

Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the remote control.

Observe the following precautions:

1.Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.

2.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

3.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

4.Battery replacement is necessary when the remote control acts sporadically or stops operating the projection display set.

Helpful Hints:

(1)For frequent remote control users, replace old batteries with Alkaline batteries for longer battery life.

(2)Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend that you record the code on page 70, prior to setting up the remote.

Getting Started

7