POSITION Menu
See “Navigating through the MENU” on page 28.
DOT CLOCK
If you have interference patterns on the projected image, which is sometimes referred to as moire or noise, you can minimize it by pressing IHto adjust the clock frequency.
H - POSITION
You can move the projected image horizontally for fine adjustment.
Move 
Move
left 
right
NOTE:
If the projecting signal’s dot clock frequency is higher than 150 MHz, the adjustment may not make a difference.
Settings
V - POSITION
You can move the projected image vertically for fine adjustment.
Move 
Move
down 
up
CLOCK PHASE
If you require further adjustment for the same reason as the DOT CLOCK adjustment, you can fine adjust the timing of the clock. Press I H to adjust.
NOTE:
If the projecting signal’s dot clock frequency is higher than 150 MHz, the adjustment may not make a difference.
CLOCK PHASE is available with PC signals, and 1 125 (1 080)/50i, 1 125 (1 080)/60i,
1 125 (1 080)/50p, 1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p and
750 (720)/60p signals of COMPONENT connection.
34 - ENGLISH
