OPTION Menu

ENGLISH - 39
Settings
When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See “Projection method”
on page 15.
You can select the required duration of time and set the
off timer to turn off the POWER of the projector
automatically. 3 minutes before turn-off, the countdown
of minutes will be displayed in the lower right corner.
Press I H to cycle through the options. See “Switching
off the projector automatically” on page 25.
If you use the projector at high elevations, set the fan
speed to HIGH. Press I H to select HIGH or LOW.
You can adjust the power of the lamp to save on
electricity, prolong the lamp life and reduce the noise.
You can check how long the lamp has been used.
You can assign frequently used functions to each
function button and access the functions instantly.
1. Press F G to select the required button to assign.
2. Press ENTER.
3. Press I H to select the required function to
assign.
4. Press RETURN or MENU to return to the previous
menu, or press repeatedly to return to the
projection.

QSHUTTER function

You can turn off the lamp and stop the projection
temporary for electrical power save. Press any
button except the LIGHT, DEVICE or Learning
Remote control buttons to return to the
projection.
INSTALLATION
FRONT/DESK Setting on a desk/floor and
projecting from front
FRONT/CEILING Mounting in the ceiling and
projecting from front
REAR/DESK Setting on a desk/floor and
projecting from rear
REAR/CEILING Mounting in the ceiling and
projecting from rear
SLEEPALTITUDE
NOTE:
At 1 400 m (4593 ft) above sea level, the setting
must be HIGH.
LAMP POWER
Options Function
NORMAL When higher luminance is
required such as movies
ECO - MODE When lower luminance is
sufficient such as in a small room
NOTE:
When no input signal is detected, the function is
disabled.
LAMP RUNTIME
NOTE:
LAMP RUNTIME is a relevant matter for lamp
replacement timing. See “Care and Replacement”
on page 41.
FUNCTION BUTTON
NOTE:
See “Selecting the input signal” on page 21,
“AUTO SETUP” on page 36.
The function buttons are also used as Learning
Remote control buttons. Press the DEVICE button
to switch the control mode. See “Remote Control
Operating Guide” provided with the projector.
OFF
OFF
OFF
FUNCTION BUTTON2
FUNCTION BUTTON3
FUNCTION BUTTON1
FUNCTION BUTTON

DISABLED SHUTTER

HDMI2 IN AUTO SETUP

HDMI1 IN VIDEO IN

PC IN S-VIDEO IN

COMPONENT2 IN COMPONENT1 IN

PT-AE1000U.book Page 39 Monday, October 16, 2006 1:40 PM