Panasonic PT-AE1000U manual Inquiry commands, Basic format, Cable specifications, Projector

Technical Information

Inquiry commands

Command		Control contents							Parameter
QPW		Power status			000 = OFF					001 = ON
QFZ		FREEZE status			0	= OFF				1 = ON
					Parameter: (page 23)					SVD = S-VIDEO IN
QIN		Input signal status			VID = VIDEO IN					HD1 = HDMI1 IN
					RG1 = PC IN					HD2 = HDMI2 IN
					CP1 = COMPONENT1 IN					CP2 = COMPONENT2 IN
QOT		SLEEP status			0	= OFF	1 = 60 min.	2 = 90 min. 3 = 120 min. 4 = 150 min.
					5	= 180 min.	6 = 210 min.		7 = 240 min. (page 25)
					Parameter: (page 25)					NOR = NORMAL
		PICTURE MODE			NAT = COLOR1
QPM					DYN = DYNAMIC					CN1 = CINEMA1
		status
					CN2 = CINEMA2					CN3 = CINEMA3
					VID = COLOR2
QSH		SHUTTER status			0 = OFF					1 = ON
					Parameter: (page 24)
					0	= OFF				5 = SINGLE LINE SCAN (Y)
QWM		WAVEFORM status			1	= FULL SCAN (Y)
					2	= FULL SCAN (R)				6 = SINGLE LINE SCAN (R)
					3	= FULL SCAN (G)				7 = SINGLE LINE SCAN (G)
					4	= FULL SCAN (B)				8 = SINGLE LINE SCAN (B)
Basic format
									The data streaming from the computer will
STX		Command		:	Parameter		ETX
									start with STX, and proceed to Command,
Start	byte								Parameter and end with ETX. You can
			1 byte				End
		3 bytes			1 byte -
(02h)							(03h)		add the required parameter.
						4 bytes

The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds before sending the command.

If sending multiple commands, check that a response has been received from the projector for one command before sending the next command.

When a command which does not require parameters to be sent, the colon (:) is not required.

If an incorrect command is sent from the personal computer, the ER401 command will be sent from the projector to the personal computer.

Appendix

Cable specifications

(When connected to a a personal computer)

NC

NC

Projector

NC

NC

NC

PC (DTE)

NC

NC NC

48 - ENGLISH