Usingthetheremoteremotecontrol control Inserting and removing the batteries
Preparation
1) Open the cover.
(ii)
(i)
2) Insert the batteries and close the cover.
zzInsert the 
side first.
zzTo remove the batteries, perform the above procedure in the reverse order.
Setting remote control numbers
When you are using multiple projectors, you can set a remote control number to each projector to allow simultaneous control with a single remote control.
After setting a remote control number to the projector, specify the same remote control number to the remote control.
■■Setting method
1) While holding the <MENU> button, press the number (<0> - <9>) buttons (2 digits) to enter the desired remote control number.
zzWhen you release your finger, the remote control number will change to the new number.
zzTo set the remote control number to 09, press <0>, <9> while holding down the <MENU> button.
Note
zzThe factory default setting is [All]. [All] supports all remote control numbers.
zzSet the remote control number of the projector using [Remote control] ( page 77) from the [Setting] menu. zzTo reset the remote control number (to set to [All]), simultaneously hold down the <MENU> button and the
<0> button for at least five seconds.
Using the remote control as a wired remote control
Connect the <REMOTE IN> terminal on the projector body to the wired remote control terminal on the remote control using the remote control cable (commercially available).
zzMake sure that the batteries are inserted in the remote control.
zzTo use the remote control wirelessly, disconnect the remote control cable from the projector and the remote control. When the remote control cable is connected, you cannot use the remote control wirelessly.
24 - ENGLISH