Attaching the lens

Attaching the lens

Attention

zzThe attachment procedure and parts vary depending on the optional lens. Check the product No. and attach the lens properly.

zzWhen using ET-ELW02, ET-ELS02, ET-ELS03, ET-ELT02, or ET-ELM01, tie up the cables using the cable ties supplied with the projector before attaching the lens. If you attach the lens without tying up the cables, the cables may contact the internal parts, causing malfunctions.

1)Install the lens attachment to the lens.

(i)Remove the lens covers on the front and rear of the lens, install the lens attachment, and secure with four screws supplied with the lens.

Lens attachment

Focus lock screw

Started Getting

Screwdriver supplied with the lens

Locate the motor on the right side.

(ii)Connect the lens motor lead connector to the socket on the top right of the lens attachment (the motor driven lens only).

Lens attachment

Socket

2)Set the projector to the standby mode,

press the side of the main power switch to turn off the power, and then unplug the power cord from the outlet.

3)Turn the lens hood counterclockwise to remove.

Lens hood

4)Remove two screws A, loosen two screws B, and slide the lens attachment cover forward to take off.

Lens attachment cover

5) Remove the cover plate.

Cover plate

Connector

Lens motor lead

26 - ENGLISH