Read this first
Minimum required setting screen
When you start the projection for the first time or after the projector is initialised, the minimum required setting screen for projection will be displayed.
LANGUAGE
Select the required language setting.
LANGUAGE |
ENGLISH |
PLEASE SELECT LANGUAGE |
SELECT |
ENTER |
Press F G I H buttons of the remote control or control panel on the projector to highlight the required language, and press the ENTER button to proceed to the next setting.
OPTION
Select the current projection method and fan speed setting. If you need return to the previous setting, press the RETURTN button.
OPTION
INSTALLATION | FRONT/DESK |
|
|
|
|
SCREEN FORMAT | 16:10 |
|
|
|
|
|
|
|
ALTITUDE | LOW |
|
|
|
|
SWITCH TO HIGH ALTITUDE MODE "HIGH" IF OVER 1400m(4593Ft).
RETURN
SELECT 
ENTER
INSTALLATION
Press I H buttons of the remote control or control panel on the projector to select the required installation method. Press G to proceed to the SCREEN FORMAT setting.
FRONT/DESK | Setting on a desk/floor and | |
projecting from front | ||
| ||
FRONT/CEILING | Mounting in the ceiling and | |
projecting from front | ||
| ||
REAR/DESK | Setting on a desk/floor and | |
projecting from rear | ||
| ||
REAR/CEILING | Mounting in the ceiling and | |
projecting from rear | ||
|
SCREEN FORMAT
Select the required screen format by pressing I H. Press G to proceed to the ALTITUDE setting.
16:10
16:9
ALTITUDE
If you use the projector at high elevation, the ALTITUDE setting need to be HIGH to set the fan speed high. Press I H to select the required option. If you need to return to the INSTALLATION, press F.
LOW | The fan speed is low. |
HIGH | The fan speed is high. |
NOTE:
•At 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, the setting must be HIGH.
•The loudness of fan noise depends on the ALTITUDE setting.
Preparation
Press the ENTER button to start the projection.
Once you finish the minimum requirement setting, it will not be displayed again unless the projector is initialised. See “INITIALIZE ALL” on page 40.
You can change each settings in the main menu. See “Menu Navigation” on page 29.
