POSITION menu
Settings
Remote control | Control panel |
MENU | RETURN |
See “Navigating through the MENU” on page 29. See “Main menu and
REALTIME KEYSTONE
If the projector is aligned
ON: Active
OFF: Deactive
KEYSTONE
If you need to correct the angle of the projection even when the REALTIME KEYSTONE is activated, you can correct the keystone manually.
Image | Operation | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
NOTE:
•You can correct the distortion ± 30 degrees from the plane. For a better quality image, installing the projector with a minimum of distortion is recommended.
•The distortion of the Main menu screen is not correctable.
•The result of the keystone correction will affect the aspect ratio and the size of the image.
POSITION
You can move the projected image for fine adjustment. Press I H to move horizontally and F G vertically. (Available with signals of
POSITION | H | 0 |
| V | 0 |
POSITION V
Only when the
DOT CLOCK
If you have interference patterns of the projected image, which is sometimes referred to as moire or noise, you can minimize it by pressing I H to adjust the clock frequency. (Available with signals of RGB only)
NOTE:
•If the projecting signal’s dot clock frequency is higher than 108 MHz, the adjustment may not make a difference.
•DOT CLOCK needs to be adjusted before adjust the
CLOCK PHASE.
CLOCK PHASE
If you require further adjustment for the same reason as the DOT CLOCK adjustment, you can fine adjust the timing of the clock. Press I H to adjust. (Available with signals of RGB/YPBPR only)
NOTE:
•If the projecting signal’s dot clock frequency is higher than 108 MHz, the adjustment may not make a difference. See “List of compatible signals” on page 49.
