Panasonic PT-LW80NTE manual Picture menu

PICTURE menu

Remote control	Control panel
MENU	RETURN

See “Navigating through the MENU” on page 29. See “Main menu and Sub-menu” on page 30.

COLOR

You can adjust the colour saturation of the projected image. (Available with signals of VIDEO/S-VIDEO/ YPBPR only)

LighterDarker

Settings

PICTURE MODE

Depending on the projection environment, you can use these preset parameter settings to optimise image projection. Press I H to cycle through the options.

NATURAL	Reproduces the original colour of
	the image
STANDARD	Setting for a general image
DYNAMIC	Bright and sharp setting
	Setting for when projecting on a
BLACKBOARD	blackboard
	See “BLACKBOARD” on
	page 39.

NOTE:

•The default setting varies according to the selected signal.

•It may take for a while until the selected mode is stabilised.

CONTRAST

You can adjust the contrast of the projected image. Adjust the BRIGHTNESS in advance if necessary.

LowerHigher

BRIGHTNESS

You can adjust the brightness of the projected image.

DarkerBrighter

TINT

You can adjust the skin tone in the projected image. (Available with signals of VIDEO/S-VIDEO/YPBPRonly)

More More

reddish greenish

SHARPNESS

You can adjust the sharpness of the projected image and the adjustable range depends on the input signal.

Less	More
sharp	sharp

COLOR TEMPERATURE

You can adjust the white balance of the projected image. Press I H to cycle through the options.

STANDARD	Balanced white
HIGH	More bluish
LOW	More reddish

DAYLIGHT VIEW

You can keep the projected image bright and vivid even in well-lit rooms where the ambient light sources cannot be controlled, such as when a door opens or when window coverings fail to block out sunlight.

AUTO: Automatic adjustment

ON: Active

OFF: Deactive

NOTE:

•Do not cover the Ambient Luminance Sensor (ALS) of the projector. See “Ambient Luminance Sensor (ALS)” on page 14.

•AUTO is not available when INSTALLATION setting in OPTION menu is set to REAR/DESK or

REAR/CEILING.

ENGLISH - 32