![](/images/new-backgrounds/1307409/30740975x1.webp)
OPTION menu
Settings
LAMP POWER
You can adjust the power of the lamp to save electricity, prolong the lamp life and reduce the noise.
STANDARD When higher luminance is required
NOTE:
•When no input signal is detected, the function is disabled.
•The
LAMP RUNTIME
You can check how long the lamp has been used.
NOTE:
•LAMP RUNTIME is a relevant matter for lamp replacement timing. See “Replacing the Lamp unit” on page 46.
•When the lamp unit is replaced with the new unit, the setting need to be reset to “0”.
POWER OFF TIMER
You can set the off timer to switch off the power of the projector after a certain period of time automatically when no signal is detected. Press I H to select the required period from 15 to 60 minutes at intervals of 5 minutes.
DIRECT POWER ON
You can switch the projector start up status for when the electric power is supplied. Press I H to select the required option.
OFF | Starts in the same mode as last use. |
ON | Skips the standby mode and starts |
| the projection. |
NOTE:
•If the projector is started from the projecting mode, the POWER button pressing procedure is skippable.
AUTO SETUP
You can turn off the automatic AUTO SETUP adjustment system.
AUTO | When the projector detect a |
| COMPUTER signal, automatically |
| set the setting of POSITION, DOT |
| CLOCK and CLOCK PHASE in |
| POSITION menu. |
BUTTON | Only when the AUTO SETUP button |
| is pressed, automatically set the |
| POSITION, DOT CLOCK and |
| CLOCK PHASE in POSITION menu |
| for COMPUTER signals. See |
| “Remote control” on page 16. |
NOTE:
• AUTO setting is recommended.
SIGNAL SEARCH
You can turn off the auto signal detecting system.
ON | Detect the input signal from the |
| terminals and project the image. |
OFF | Deactive |
NOTE:
•SIGNAL SEARCH is not available when any input signal is projected.
INSTALLATION
When installing the projector, select the projection method according to the projector position. Press I H to cycle through the options. See “Projection method” on page 18.
FRONT/DESK | Setting on a desk/floor and | |
projecting from front | ||
| ||
FRONT/CEILING | Mounting in the ceiling and | |
projecting from front | ||
| ||
REAR/DESK | Setting on a desk/floor and | |
projecting from rear | ||
| ||
REAR/CEILING | Mounting in the ceiling and | |
projecting from rear | ||
|
CONTROL PANEL
You can turn off the function of the control panel buttons on the projector body. Press I H to select the required option.
VALID | Validate the control panel buttons |
INVALID | Invalidate the control panel buttons |
| The confirmation screen will be |
| displayed. |
ALTITUDE
If you use the projector at high elevation, the ALTITUDE setting need to be HIGH to set the fan speed high. Press I H to select the required option.
LOW | The fan speed is low. |
HIGH | The fan speed is high. |
NOTE:
•At 1 400
•The loudness of fan noise depends on the ALTITUDE setting.