Runco SC-50D, SC-60D Installing the Primary Projection Lens, Projector, Security Screws

Installation

The projection lens is shipped separately from the projector. Proceed as follows to install it:

1. Remove the lens plug from the lens opening in the projector.

Never operate this projector without a lens. The lens seals the WARNING projector, preventing contaminants from entering the interior of the

projector.

2.Remove the rear cap from the lens. (Keep the front lens cap on the projection lens to protect it from damage during the installation process.)

3.Rotate the lens clamp to the OPEN position.

CLAMP OPEN

CLAMP CLOSED

SECURITY

SCREW

SECURITY

SCREW

MOUNTS

4.Remove and retain the two security screws from the lens mount.

Security

Screws

3.4

Installing the Primary Projection Lens

5.Align the lens interface plate with the lens mount. Align the lens electrical connector with the mating connector on the lens mount. Fully insert the assembly straight into the lens mount opening without turning. Press using your hand.

Note	When installing the lens, ensure that it is not inserted at an angle, as
	this can cause damage.

6.While holding the lens flat against the lens mount, rotate the lens clamp clockwise to lock the lens assembly in place.

7.Re-attach the lens mount security screws that you removed in Step 4.

8.Remove the front lens cap.

Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 25