Runco SC-50D, SC-60D 1.RS232 IN, Pwr Led, Dual-Link DVI-IInput Slot, Analog LED, Digital LED

Controls and Functions

1.RS232 IN

Connect the RS-232 output from the DHD Controller here, using the provided RJ11-to-DB9 adapter and communication cable.

2.PWR LED

Lights green to indicate that power is applied and the module is initialized. During normal operation, always on.

3.1 - Dual-Link DVI-I Input (Slot 2)

HDCP-compliant digital video input. Connect the HDMI output from the DHD Controller to this input (see Figure 2-4).

4.Analog LED

Lights briefly when the projector is powered up (self-test). During normal operation, always off.

5.Digital LED

Lights green to indicate that a valid digital signal from the DHD Controller is present.

6.MAIN POWER SWITCH

Disconnects or applies power to the SC-50d/SC-60d.

7.POWER INPUT (100 to 240 VAC) Connect the projector to power here.

Use ONLY the AC power cord shipped with the WARNING SC-50d/SC-60d for this purpose (the one with the ferrite

sleeve). Doing otherwise creates a fire hazard risk.

Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 7