Runco SC-50D, SC-60D Turning on the Power, Primary Lens Adjustments Focus, Zoom and Position

Installation

1.Power up your source components.

2.Turn on the main power switch at the rear of the projector.

3.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input (see Figure 3-18).

4.Turn on the main power switch at the rear of the DHD Controller.

5.Press the ON button on the remote control (or the ON/STANDBY ( ) button on the DHD Controller front panel) to turn on the system. The vacuum fluorescent display on the DHD Controller front panel briefly displays “Initializing System,” followed by “Starting SC-50d/SC-60d.”

6.When the display is ready for use, the fluorescent display indicates the active source, input resolution/frame rate and aspect ratio; for example:

		Current
		Source
SC-50d/SC-60d
	HDMI 1
16:9
	1080p/60

3.8

Turning on the Power

Aspect Ratio Input Resolution/Frame Rate

Lens zoom, focus and position are motorized adjustments that are adjustable using the Setup remote control (Figure 2-6). This allows you to adjust the focus and image size while at the screen for more accurate results.

For maximum range, point the remote directly at the projector.

Tip

To access the lens controls, press the MAIN button on the Setup remote control to display the Main Menu page (if not already displayed). Then:

• Focus: To focus the projected image, press

FOCUS, then press and hold the FCUS or
FCUS button.	FOCUS
• Zoom: To make the picture smaller (zoom out),
	ZOOM
press ZOOM, then press and hold the ZOOM-
	LENSS
button. To enlarge the picture (zoom in), press and
hold the ZOOM+ button.
• Lens Shift: To change the lens (and projected
image) position, press LENSS, then press and
hold the LENS , LENS , LENS or LENS
button.

3.9

Primary Lens Adjustments: Focus, Zoom and Position

Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 41