Runco SC-60D, SC-50D operation manual Attach Lens Mounting, Assembly to Lens Motor, Carriage Plate

Installation

Attach Lens Mounting ➤ 1.		Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Assembly to Lens Motor		Anamorphic Lens Holder (item #5).
Carriage Plate	2.	Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate (item #7).
		Position the bracket so that the long slot at the bottom of the lens holder is
		perpendicular to the corresponding slots on the plate.
	3.	Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers
		(item #6) and Yaw/X Adjustment Levers that you removed in Step 1.
	4.	Use the Lens Mounting Screws to attach the Lens Adapter Ring (item #1) to the Pitch
		Adjustment Yoke (item #2); see Figure 3-24.(Use the round, threaded holes on the
		yoke.)
	5.	Use the Height/Y Adjustment T-Screws/Washers (item #3), Pitch Adjustment
		T-Screws/Washers (item #4) and T-Nuts (item #9) to attach the Pitch Adjustment
		Yoke and Lens Adapter Ring to the Anamorphic Lens Holder. The Yoke should be
		as close to the primary lens as possible.
	6.	Attach the lens to the Lens Adapter Ring by threading it clockwise.

Lens threads into ring

SUCO

F

Figure 3-24. Attaching the Anamorphic Lens to the Lens Ring

46 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual