Runco SC-60D, SC-50D operation manual Ethernet Network Connection to DHD Controller

Installation

Ethernet Network Connection: Use a standard, Category 5 network cable with an RJ-45 plug to connect a network hub, router or gateway to the Ethernet port on the DHD Controller; see Figure 3-20.For more information about configuring and using this connection, refer to Network on page 71.

	RS-232	Display Control
				IR
To Accessory Box
HDMI 3			HDMI Out
			To Display

HDMI 4	Ethernet	HDMI Out
		Audio Only

8 1

to Ethernet

1 Transmit Data +

Hub, Router

2 Transmit Data -

or Gateway 3 Receive Data + 6 Receive Data -

Figure 3-20. Ethernet Network Connection to DHD Controller

Connecting to AC Power ➤ Projector and DHD Controller: The SC-50d/SC-60d ships with two (2), AC power cords: one for the DHD Controller and one for the projector. They are not interchangeable. The projector power cord is rated at 15 amps and has a ferrite sleeve, to reduce radio frequency interference (RFI) emissions to a level that conforms to FCC regulations:

AC power cord Ferrite sleeve

To power outlet To Projector AC IN

Plug the female end of the projector power cord into the AC receptacle on the rear of the

SC-50d/SC-60d (AC 100V ~ 240V); see Figure 2-2.Then, connect the other end to your

AC power source.

Use ONLY the AC power cord with the ferrite sleeve to

WARNING connect the projector to AC power. Doing otherwise creates a fire hazard risk.

Connect the DHD Controller to a nearby AC outlet using the other AC power cord.

AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power cord is provided for the lens motor. Plug the female end of the AC power cord into the AC input on the rear of the lens motor assembly. Connect the other end to your AC power source.

40 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual