Runco SC-60D, SC-50D operation manual Remove Projector Front, Feet, Install Anamorphic Lens, Motor

Installation

3.5

Installing the Optional CineWide with AutoScope Lens Motor

If you are installing a standard SC-50d/SC-60d (without an anamorphic lens), skip this step and proceed with Mounting the SC-50d/SC-60d(page 27).

If you are installing an SC-50d/CineWide with AutoScope or SC-60d/CineWide with AutoScope, proceed as follows to install the lens mount/motor assembly.

	Note	1. Do not install the CineWide lens yet, only the AutoScope lens
		motor. You will install the CineWide lens after you install the
		projector and adjust the primary lens.
		2. Some components shipped with your projector may differ slightly
		from what is shown in these instructions.
		3. The anamorphic lens mounting kit is partially pre-assembled at
		the factory – the AutoScope lens motor and lens mounting
		assemblies are both fully assembled.
Remove Projector Front ➤	Place the projector upside down on a blanket or other soft surface. Loosen and remove
Feet	the two front feet on the projector.
Install Anamorphic Lens ➤	Line up the eight mounting holes on the lens motor housing with those on the bottom of
Motor	the projector. Secure the motor to the projector with the eight screws provided for this

purpose. See Figure 3-7.Then, connect the +12V trigger input on the motor to a +12V trigger output on the DHD Controller as shown in Figure 3-18.

Figure 3-7. Attaching the AutoScope Lens Motor to the Projector

Caution

DO NOT OVER-TIGHTEN THE SCREWS.

26 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual