Runco SC-50D, SC-60D operation manual If a Display Error, a device-specific

Operation

•E-Mail Notification: Select E-Mail Notification from the Network menu to specify when and to whom the DHD Controller sends error and service notification messages via e-mail.

The notification messages are in the following format:

To: [E-Mail Address; see below]

From: do-not-reply@runco.com

Subject: [Type of notification] from Runco DHD4 Body:

This is an automated message sent from the Runco DHD4:

Notification:	[One of the following:
	“DHD Error” / “Display Error”
	“Periodic Service Notification”
	“Lamp Life Notification” / “Calibration Data”]

Detailed Description: [ If a DHD Error, one of the following: “Fan Failure 1” / “Fan Failure 2” “Overtemp 1” / “Overtemp 2” “Initialization Failure”

	If a Display Error, a device-specific
	error message such as “Lamp Door Open”
	If a Periodic Service Notification, the elapsed
	time since the last notification
	If a Lamp Life Notification, the number of hours
	the lamp has been in service
	If a Calibration Data message,
Serial Number:	“See Attached File” ]
	[DHD Controller serial number]

Customer Information: [From “Customer Information“ sub-menu; see below]

Best Regards,

Runco International, LLC 1195 NW Compton Drive Beaverton, OR 97006 1-800-237-8262

•E-Mail Address: To specify the destination e-mail address for error and service notifications, select E-Mail Address from the E-Mail Notification menu. The procedure is similar to that for setting the IP address (refer to IP Configuration on page 71). Enter up to 45 alphanumeric characters.

•Error Notification: To have the DHD Controller send a message to the destination e-mail address when a “DHD Error” or “Display Error” occurs, select Error Notification from the E-Mail Notification menu and set it to On.

•Error Notification to Runco: To have the DHD Controller send an e-mail message to Runco Customer Support when a “DHD Error” or “Display Error” occurs, select Error Notification to Runco from the E-Mail Notification menu and set it to On.

Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 73