INSTALLATION
REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Tools needed
■Adjustable wrench
■Slip joint pliers
■#2 Phillips screwdriver
■Basin wrench (optional)
Tools needed
Remove parts from carton. Check that all parts are included.
All models:
■Faucet assembly
■Plastic base
■⁵⁄₆₄" (2 mm) Allen wrench
Model series KKFV01SP & KKFV01PP:
■Weights
■Check valve assembly
–2 fiber seals
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■Check location where faucet will be installed. Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with installation specifications and with state and local plumbing codes. Protect faucet and water lines leading to faucet against freezing. Damage from freezing is not covered by the warranty.
■Faucet requires a 1³⁄₈" (3.5 cm) diameter opening in sink or countertop. If hole is not available for mounting it is recommended that a qualified installer be contacted to drill the hole for your installation in a sink deck or countertop. Thickness of sink or countertop hole must not exceed 1³⁄₄"
(4.4 cm).
■Hot and cold water supply lines must be available and if they are not it is recommended that a qualified plumber install the necessary piping.
■Faucet hoses are equipped with compression type seals and do not require sealing compounds to prevent leaking.
■As with all metal objects, follow proper handling techniques.
■It is recommended that a qualified plumber/installer install the faucet. The faucet installation must comply with national and local plumbing codes and ordinances.
■The faucet should be examined for damage prior to installation. Do not install a damaged faucet. Instead, return the faucet to the dealer from whom you purchased it. Failure to do so will void the warranty.
INSTALLATION
INSTRUCTIONS
1.Before installing the faucet, flush water supply pipes thoroughly. Shut off water supply valves.
2.Remove nut, metal washer and rubber washer from faucet. Do not remove rubber
A
B
C
A. Rubber washer
B. Metal washer
C.Nut
3.Feed tubing through hole in sink or countertop and then insert faucet assembly into hole.
4.Reinstall the parts onto the threaded shank of the faucet in the following order: rubber washer, plastic base, metal washer and nut.
A
B
C
D
A. Rubber washer
B. Plastic base
B. Metal washer
C.Nut
5.Align faucet and securely
2