Kathrein UFD 515 manual Installation menu, Mode, LNB configuration

Setting system parameters

A/V mode

Here, you use the ￿￿buttons to select the type of video signal which is present on the Scart socket. Select the signal which your TV set is able to process.

Observe the operating instructions of your television set!

￿￿FBAS –composite baseband signal (colour-/picture-/blanking- /synchronising-signal)

￿￿RGB – red-/green-/blue-signal

￿￿Y/C – S-VHS signal (luminance/chrominance). Confirm by pressing ￿two times.

Installation menu

You should not change the following settings without good reason as they represent factory settings or operational settings that are adapted to your receiving system.

New settings are only required when changes or expansions are made to the receiving system.

The main menu consists of the following submenus:

Select the "Installation" menu with the menu button ￿, the

￿￿buttons in the main menu and ￿. If set, you must also

enter the password. Select the menu points with the ￿￿ buttons.

LNB configuration

The first submenu is the "LNB configuration". Press ￿to open this menu. Normally, you should not make any changes in this submenu.

Before making any changes, however, you should make a note of the settings in the form provided at the end of this User's Guide.

Your receiver is set at the factory to the satellites of the ASTRA and

54