Setting system parameters
receiver to the receiving system for signal selection, are also recognised by this system.
A remote frequency must not be set in this operating mode, because it is defined by the UFO micro system as part of the addressing procedure.
You will need to delete the previously allocated address when using the receiver for the first time together with a UFOmicro receiving system. You can do this under the UFOmicro menu point by selecting
"Reset" with the buttons and pressing .
The original factory setting is then allocated to the receiver. It must then be reset to ON. The receiver will then receive a new address from the new system.
The pre-programming is not deleted with "Reset".
Presetting: OFF
Factory setting
Under this menu point, you can reset all the settings to the factory setting by pressing .
The factory settings need not necessarily correspond to the settings required for your system!
After the reset, it may be necessary to repeat all settings.
64
