Kathrein UFD 515 manual Tone burst

Setting system parameters

Tone burst

Under this menu point, the 22 kHz signal can be set as follows:

Switching statuses of setting:

22-kHz signal	—> High/Low
	and
Tone Burst—> Pos. A/B:
Low	22-kHz	Off
High	22-kHz	On
Pos. 1	Tone burst	0
Pos. 2	Tone burst	1

Switching statuses of setting:

22-kHz signal		—> Pos. A/B
Tone burst	and	—> Opt. A/B
Pos	Tone burst		22-kHz
1	0		Off
2	0		On
3	1		Off
4	1		On

Switching statuses of setting:

22-kHz signal		—> Pos. A/B
	and
Tone Burst	—> High/Low
Low	Tone burst		0
High	Tone burst		1
Pos. 1	22-kHz		Off
Pos. 2	22-kHz		On

DiSEqC

If the receiver is connected to a DiSEqC switching matrix, you will need to set this menu point to ON.

The switching criteria and the input assignments of the DiSEqC switching matrix must be maintained. Therefore, refer to the description of the switching matrices or contact the installer of the receiving system.

DiSEqC Repeat

The DiSEqC command must be repeated if the receiver is operated (cascaded) together with a receiving system with two or more series connected DiSEqC switching matrices.

In this case, switch the menu point "DiSEqC repeat" to 1 or 2. Factory presetting: OFF

UFO mini

The input frequency of the receiver is fixed in a "user-controlled processing system". The signals from the "user-controlled processing system" are transmitted on this frequency. The reception parameters for programme selection are transferred to the receiving system by means of a DiSEqC command and set accordingly.

The relevant setting, which needs to be selected, depends on the type of "user- controlled processing system".

The setting should be made according to the data provided in the installation instructions for the "user-controlled processing system".

Remote frequency

If you have set the UFO mini menu point to ‘ON,’ you will need to set the transmission frequency under this menu point.

Refer to the installation instructions of the "user-controlled processing system" for the set transmission frequency.

Therefore, it is important to refer to the information provided in the installation instructions of the "user-controlled processing system".

UFO micro

The setting under this menu point is also designed for operation of the receiver together with a processing system.

Control and communication between the receiver and the Kathrein UFO micro system occur via the return path of the coaxial cable. ‘ON’ must be set under the UFO micro menu point, if the receiver is operated together with a UFO micro receiving system.

During installation, the receiving system assigns a special address to the receiver so that the control instructions, which are sent from the

63