INSTALLATION
Continued
WARNING:Failuretoconnect all wires properly as indicated maycauseelectricalshortcircuit or personal injury. A qualified electrician should check that all connections are made properly.
12.Plug in blower power cord.
a.If your firebox is installed as a free- standing unit with an accessory mantel, determine whether the power cord will exit the left side or the right side of the firebox. Install one plastic bushing provided into the 1 1/2" hole in the floor support on the exit side. Install the second bushing provided into the 1 1/2" hole in the outer casing through which the power cord will exit (see Figures 21 and 22). Route power cord through plastic bushings and plug the power cord into a properly grounded three- prong wall receptacle near the firebox.
b.If your fireplace system installation is recessed and if an outlet is not installed in your fireplace, you must install the GA3555 Outlet kit with cover in your fireplace which will supply a convenient
13.Check to make sure that the power cord and all wires are completely clear of the blower wheel and that there are no other foreign objects in blower wheel.
CAUTION: Never touch the blower wheel while in operation.
14.Peel off backing paper and stick supplied wiring diagram decal near center of firebox bottom (see Figure 23).
15.If gas connections have been made and checked, replace fireplace floor assembly in fireplace. Feed flexible gas supply line into fireplace base area while replacing fireplace floor assembly. Make sure the entire flexible gas line is in fireplace base area. IMPORTANT: Do not pick up fireplace floor assembly by burners. This could damage burners. Only handle base by grates. Note: Be careful of all wires and components on underside of floor assembly.
Right Floor | Plastic | |
Support | ||
Bushing | ||
Bracket | ||
|
Figure 21 - Installing Plastic Bushing for
Power Cord (Right Side Exit Shown)
| Plastic |
| Bushing |
Bushing | Bushing Location for |
Recessed Installation | |
Location for |
|
Freestanding |
|
Installation |
|
Figure 22 - Installing Bushings | |
(Left Side Exit shown) |
Wiring
Diagram
|
| Variable |
| Fan Switch |
| Fan Switch | |||
|
|
|
| (N.O.) |
| Off | 1 | Black |
|
| 2 |
| ||
|
| On | Blue | |
|
|
|
| Red |
110/115 |
|
|
|
|
V.A.C. | Black |
|
|
|
|
|
|
| |
| Green |
|
| Blower |
| White |
|
| Motor |
Figure 23 - Location of Wiring Diagram Decal 3" from Blower
16 | www.desatech.com |