INSTALLATION
Continued
9.Check to make sure that all electrical cords are completely clear of the blower wheel and that there are no other foreign objects in blower wheel. Turn blower on and check for operation. Turn blower off by rotating knob fully counterclockwise before continuing.
CAUTION: Never touch the blower wheel while in operation.
10.Peel off backing paper and stick supplied wiring diagram decal near center of firebox bottom (Figure 17).
11.If gas connections have been made and checked, replace fireplace floor assembly. Feed flexible gas supply line into fireplace base area while replacing fireplace floor as- sembly. Make sure the entire flexible gas line is in fireplace base area.
IMPORTANT: Do not pick up fireplace floor assembly by burners. This could damage burners. Only handle base by grates. Note: Be careful of all wires and components on underside of floor assembly.
12.Reattach fireplace floor assembly with screws removed in step 3 of Removing Fire- place Screen and Floor Assembly, page 9.
Note: Discard the remaining hardware items. After assembly, make sure all wires are com- pletely clear of blower wheel.
13.Install logs (see Installing Logs, page 24 and fireplace screen (see Installing Screen, page 25).
Right Floor | Plastic | |
Support Bracket | ||
Bushing | ||
| ||
Figure 16 - Installing Plastic Bushing for | ||
Power Cord |
|
WARNING:Failuretoposition thepartsinaccordancewithsup- plied diagrams or failure to use only parts specifically approved with this heater may result in damage or personal injury.
WARNING:Aqualifiedservice person must connect fireplace to gas supply. Follow all local codes.
Wiring
Diagram
|
|
|
|
| Variable |
|
|
|
| |||
|
|
|
| Fan Switch |
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Black | Off | Black | On |
|
|
|
| ||
110/115 | Black |
| Black | Blower | ||||||||
| V.A.C. |
|
|
|
|
|
| Motor | ||||
|
|
| Green |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
| White |
|
|
|
| White |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 17 - Location of Wiring Diagram
Decal 3" from Blower
Operating the Blower Light your gas appliance with the blower off. After about 15 minutes, turn the blower on to deliver heated air at the top louvers. The blower features a variable control which allows you to select the speed you desire. Note: Periodically check the louvers of the firebox and remove any dust, dirt or other obstructions.
14 | www.desatech.com |