7
Getting Started
Accessories
Requires two AA batteries (supplied).
1.Turn the Transmitter face down.
Remove top cover by pressing
down on marking and sliding cover
off in the direction indicated.
2.Install the batteries as shown in the
battery compartment.
(Polarity + or – must match the
markings in the compartment).
3.Replace the cover and slide in
reverse until the lock snaps.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend
that you record the code on page 62, prior to setting up the remote.

Helpful Hint:

For frequent remote control users, replace old batteries with Alkaline batteries for longer life.
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
3. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
4. Battery replacement is necessary when the remote control acts sporadically or stops operating the projection display
set.
Two AA size
Remote Control Battery Installation
(1) Remote Control (EUR7603Z80)
(2) Batteries 2 “AA”
(3) RGB Cable (2 m) (LSJA0239-1 or LSJA0443)
(4) Accessory Air Filter (LSYC0239)

Before Using

Helpful Hint: