Remote Control Battery Installation

Requires two AA batteries (supplied).

1. While pressing in on the catch, open cover in direction of arrow.

Helpful Hints:

(1)

Frequent Remote Control users, choose

edStartGetting

 

 

long-lasting Alkaline batteries as replacements.

 

(2)

Whenever batteries are removed, you may laonlo

cesse Remo

 

 

 

2. Install batteries in the battery compartment.

•Battery polarity (+) and (-) must match the markings inside the compartment.

3. Press cover until it snaps shut.

Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the Remote Control.

Observe the following precautions:

1.Always replace batteries with a pair of new ones.

2.Do not combine a new battery with an old one.

3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when the Remote Control acts sporadically or stops operating the Projection Display set.

Emergency Alert System (EAS) Forced Tuning

If a CableCARD™ is installed, the cable MSO (multiple system owner/operator) may provide an Emergency Alert System message. These messages are intended to alert the general public of important local or national emergency situations. In the event of receipt of one of these messages, the Projection Display shall immediately tune to the channel as directed by the EAS message. If the channel has been blocked using the parental control, the parental blocking has priority over the forced tune.

7