Panasonic PV-DV73 operating instructions Copying from Digital Equipment dubbing

Editing Features

Copying from Digital

Equipment (dubbing)

High quality digital-to-digital copying can be accomplished if both Palmcorders incorporate the DV Input/Output (i.LINK) Connector (DV Interface cable (i.LINK) is not supplied).

Before you begin

•Connect both Palmcorders to their power sources.

•Connect the two Palmcorders using the DV Interface cable (i.LINK)

(4-pin to 4-pin).

•Turn both Palmcorders ON.

Source (Playing)	1 Insert a pre-recorded tape into the
Palmcorder
	source (playing) Palmcorder, and set
	POWER to VCR.
DV Input/Output	2 Insert a blank tape with the record
(i.LINK) Connector
	tab closed into the target (recording)
	Palmcorder and set POWER to VCR.
Recording	3 Press
Palmcorder		(PLAY) on the source
	Palmcorder. When the tape reaches
	the point from which you want to start
DV Interface	dubbing, press (PAUSE).
Cable (i.LINK)	4 Hold down (REC) and press
(optional)
	(PLAY) on the target (recording)
	Palmcorder.
	Press	(PAUSE) to pause the tape at
3, 4, 5 3, 4PLAY	the starting point of the dub.
	5 Simultaneously, press (PAUSE) on
PAUSE
	both units to begin dubbing.
6STOP	6 Press	(STOP) on the recording
	unit, and then press (STOP) on the
	playing unit to end dubbing.

Note

• When two Palmcorders are used for

4RECdubbing, it is recommended that the Remote Control VCR1 or VCR2 setting be used to avoid improper-operation.

Editing Features

3, 4, 5	4REC
PAUSE
6STOP	3, 4	CAUTION:
	PLAY

Unauthorized exchanging and/or copying of copyrighted recordings may be copyright infringement.

47