Panasonic PV 27DF63, PV 20DF63 operating instructions Connections, Initial Setup Ready to Play

Initial Setup (Ready to Play)

Please make all cable or antenna connections before powering on.

Connections

For ANT./Cable

Connect the cable from Antenna/Cable to the VHF/UHF terminal on the unit.

For DSS/Cable Box

Connect the OUT jack on your cable box to the VHF/UHF terminal on the unit with a RF cable.

VHF/UHF

VHF/UHF

IN from

ANT./CABLE

Cable TV

Converter Box

WARNING

Overtightening “Nut type” RF coaxial cables may damage jacks. Finger tighten only.

	IN from
VHF/UHF	ANT./CABLE

VHF/UHF

Initial Setup (Ready to Play)

Plug the unit power cord into an AC

1 wall outlet.

Press POWER* on the remote or unit.

2 The unit comes on and auto channel and clock set starts.

CH AUTO SET PROCEEDING AUTO CLOCK SET

PROCEEDING

CANCEL : PRESS STOP KEY

•If you use a cable box, turn it on and set it to the Public Broadcasting Service (PBS) channel in your time zone. If you use a DSS receiver, it must be turned off.

Settings are made automatically. When

3 setup is done, this screen appears.

2/ 6/2003 THU 12: 00PM

DST : ON

SETT I NG : CH 10

AUTO CLOCK SET

COMPLETED

If AUTO CLOCK SET IS INCOMPLETE screen appears, set the clock using MANUAL CLOCK SET procedure on next page.

AUTO CLOCK SET

I S I NCOMPLETE

PLEASE SET CLOCK BY

PRESSING ACT I ON KEY

Notes

•Function buttons are inoperative during Initial Setup.

•Depending on conditions, Auto Clock Set may take longer than 30 minutes. If so, press STOP to stop setup and perform settings manually. (See page 12-13.)

10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com