Panasonic SC-AK350, SC-AK450 Cassette tape Play and record, Recording, TPS Tape Program Sensor

Cassette tape – Play and record

The buttons described for “Cassette tape - Play and record” are mainly for the main unit unless indicated otherwise.

TAPE

Basic play

Use normal position tapes.

High position and metal position tapes can be played, but the unit will not be able to identify the characteristics of these tapes.

1 Press [3, TAPE].

The unit turns on.

If a cassette was loaded, play starts automatically (One touch play).

2 Press [0, OPEN] and insert the cassette.

Insert with the side to be played facing towards you and the exposed tape facing down. Close the holder by hand.

3 Press [3, TAPE] to start play.

To	Action
stop tape playback	Press [7, STOP].
fast-forward and	Press [ , REW / 4] or [ , FF / ¢].
rewind

Note:

•Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism.

•Tape slack can get caught up in the mechanism and should be wound up before the tape is played.

TPS (Tape Program Sensor)

This function enables you to search the beginning of up to a maximum of 9 tracks.

Press [ , REW / 4] or [ , FF / ¢] during play. Play resumes from the track found.

Note:

TPS may not operate correctly in the following situations:

•If the interval between tracks is less than 4 seconds.

•If there is noise between tracks.

•If there are silent parts within tracks.

2 Select the source to be recorded. Radio recording:

Tune in the station. (\ page 12)

Disc recording:

1Insert the disc(s) you want to record. Press [6, CD] and then [7, STOP].

2Prepare the desired disc recording mode.

To	Action
record
programmed	Perform steps 2 to 4 in “Program play”
tracks
	(\ page 9).
	Perform steps 3 to 6 in “Program play”
	(\ page 9).
By remote control only
record	1) Press [DISC] and then [1] ~ [5] to select
specifi c	the disc.
discs/tracks	Ensure disc is stopped.

2) Press [PLAY MODE] to select the desired mode (\ page 8).

3)

For 1-ALBUM mode and 1-TRACK mode: Press [ALBUM ( or )] to select the album.

For 1-TRACK mode:

Press [4, / REW] or [¢, / FF ] to select the track.

3 Press [¶, REC] to start recording.

Other basic operations

To	Action
stop recording	Press [7, STOP].
record on the other	Turn the cassette over and press [¶, REC].
side of the tape
erase a recorded	1) Press [3, TAPE] and then [7, STOP].
sound	2)	Insert the recorded cassette.
	3)	Press [¶, REC].

Note:

Changes to volume and sound adjustments quality do not affect recording.

ENGLISH

DANSK

FRANÇAIS

LANG - 4

Recording

Selection of tapes for recording

Use normal position tapes.

High position and metal position tapes can be used, but this unit will not be able to record or erase them correctly.

Preparation

Wind up the source tape so recording can begin immediately.

1 Press [0, OPEN] and insert the cassette to be recorded.

Insert with the side to be recorded facing towards you and the exposed tape facing down.

Erasure prevention

The illustration shows how to remove the tabs to prevent recording. To record on the tape again, cover as shown.

Side A

Tab for side B Tab for side A

To re-record

Normal cassette

Adhesive tape

LANG - 5

RQTV0199

11

RQT8043