Troubleshooting guide
Before requesting service, make the following checks. If you can’t fix the system as described below, or if something not listed here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact your dealer.
Reference pages are shown as black circled numbers 4.
Common problems
Although the unit is in standby | Turn off the demo function. 5 |
mode, the display lights up and | If you set the clock, demo function will be turned off automatically. $ |
changes continuously. |
|
No sound. | Turn the volume up. |
Sound stops. | Switch off the unit, determine and correct the cause, then switch the unit on. |
| Causes include straining of the speakers through excessive volume or power |
| and using the unit in a hot environment. |
Sound is unfixed, reversed or | Check the speaker connections. 4 |
comes from one speaker only. |
|
Humming heard during play. | An AC power supply cord or fl uorescent light is near the cables. Keep other |
| appliances and cords away from this unit’s cables. |
“ERROR” is displayed. | Incorrect operation performed. Read the instructions and try again. |
“– | You plugged the AC power supply cord in for the fi rst time or there was a power |
standby mode. | failure recently. |
| Set the time. $ |
“F61” is displayed. | Check and correct the speaker cords connection. 4 |
| If this does not fi x the problem, there is a power supply problem. Consult the |
| dealer. |
|
|
Listening to the radio |
|
ENGLISH
DANSK
Noise is heard.
The stereo indicator flickers or doesn’t light.
Sound is distorted.
A beat sound is heard.
A low hum is heard during AM broadcast.
Use an outdoor antenna. 5
Turn the TV off or separate it from the unit.
Separate the antenna from other cables and cords.
FRANÇAIS
When there is a television set nearby
The picture on the TV disappears | The location and orientation of the antenna are incorrect. If you are using an |
or stripes appear on the screen. | indoor antenna, change to an outdoor antenna. |
| The TV antenna wire is too close to the unit. Separate the antenna wire of the TV |
| set from the unit. |
|
|
Using the cassette deck |
|
|
|
Poor sound quality. | Clean the heads. ~ |
Recording is not possible. | If the erasure prevention tabs have been removed, cover the holes with adhesive |
| tape. " |
|
|
Playing discs |
|
LANG - 4
The display is wrong or play won’t start.
The total number of tracks displayed differs each time the same disc is inserted. Unusual sound is heard.
The disc may be upside down. 3 Wipe the disc.
Replace the disc if it is scratched, warped, or
The disc may be scratched, or its data may be defective. Replace the disc.
The disc was incompletely formatted. Use the recording equipment to fully format the disc before recording.
The unit cannot display the remaining play time for variable bit rate (VBR) tracks.
LANG - 5
RQTV0199
17
RQT8043
