25
RQTX1097 ESPAÑOLESPAÑOLESPAÑOLESPAÑOLESPAÑOL
Troubleshooting guide Before requesting ser vice, make the following checks. If you are in doubt about some of t he check points, or if
the solutions indicated in the chart do not sol ve the problem, consult your dealer for instructions.
■ Common problems Page
When the unit is in
standby mode, the
display lights up and
changes continuously.
• Press and hold [8] on the m ain unit to select “DEMO OFF”. —
No response from the
unit even though it has
been turned on.
• Press [1] for more than 10 seconds to turn off the unit. Alternatively,
unplug the AC mains lead and plug it in after a lapse of a few seconds.
Turn the unit on again.
—
No response when
remote control buttons
are pressed.
• Check that the batteries are i nstalled correctly. 6
Distorted sound or no
sound.
• Turn the volume up.
• Turn off the unit, determine and correct the cause, then turn the unit on
again.
It may be caused by straining of the s peakers through excessive
volume or power, and using the unit in a hot environment.
—
—
A “humming” sound
can be heard during
play.
• An AC mains lead or fl uorescent light is near the unit. Keep other
appliances and cords away from the unit.
—
■ Discs
Incorrect display or play
will not start.
• You have not inserted the disc correctly; insert it correctly.
• Disc may be dirty. Wipe it clean.
• Replace the disc if it is scratched, warped, or non-standard.
• Condensation has formed: Wait 1 to 2 hours for it to evaporate.
10
—
—
—
The total number of
tracks displayed is
incorrect.
The disc cannot be
read.
Distorted soun d is
heard.
• You have inserted a disc the unit cannot play; insert one it can.
• You have inserted a disc that has not been fi nalised or completely
formatted.
—
—
■ Radio
Distorted soun d or
noise is heard.
The stereo indica tor
fl ickers or does not light .
• Use an optional outdoor ante nna for FM radio. The antenna should be
installed by a competent technician.
7
A beat sound is heard. • Turn the television off or move it away from the unit.
• Switch to either BP 1 or BP 2 when in AM tuner mode.
—
13
A low hum is heard
during AM broadcast.
• Separate the antenna from other c ables and cords. —
AKX50_EB_EN.indd 25AKX50_EB_EN.indd 25 6/8/2010 5:25:28 PM6/8/2010 5:25:28 PM