Panasonic SC-BT100 warranty Enjoying the FM/AM radio, Manual tuning, Presetting stations manually

Enjoying the FM/AM radio

[SELECTOR] [X], [W]

[FM/AM]

Numbered buttons

[6, 5] [:, 9]

[OK]

[2, 1]

[FM MODE] [AM BP]

QT9129

18

Manual tuning

1Press [FM/AM] to select “FM” or “AM”.

Main unit: Press [SELECTOR].

2Press [6, 5] to select the frequency.

Main unit: Press [X] or [W].

≥When a radio broadcast is being received, “TUNED” lights in the

display.	TUNED
≥When a stereo broadcast is being received, “ST” lights in the
display.	TUNED	ST

≥To start automatic tuning, press and hold [6, 5] until the frequency starts scrolling. Tuning stops when a station is found.

Presetting stations manually

Up to 30 stations can be set in each band, FM and AM.

1Press [FM/AM] to select “FM” or “AM”.

2 Press [6, 5] to select the frequency. 3 Press [OK].

“P” and “M” begin to flash.

M

4 Press the numbered buttons to enter	e.g., “12”
preset channel number.
≥To select a 1-digit number
e.g., “1”: [1] > [OK].
≥To select a 2-digit number
e.g., “12”: [1] > [2].

≥A station previously stored is overwritten when another station is stored in the same channel preset.

≥Repeat steps 2 to 4 to set other stations.

Selecting the preset channels

1Press [FM/AM] to select “FM” or “AM”.

2Press the numbered buttons to select the channel.

≥To select a 1-digit number	e.g., “12”
e.g., “1”: [1] > [OK].
≥To select a 2-digit number
e.g., “12”: [1] > [2].
Alternatively, press [:, 9] or [2, 1] to select the
channel.

If noise is excessive

	When “FM” is selected
NOTE	Press [FM MODE] to display “MONO”.	TUNED MONO
	≥Press the button again to cancel the mode.

≥The mode is also canceled when you change the frequency. ≥This setting can be preset for each broadcasting station. When

“MONO” appears follow procedures 3 and 4 in “Presetting stations manually” (> above).

When “AM” is selected

Press [AM BP] to select “AM BP1” or “AM BP2” that receives good reception.

Each time you press the button:	e.g., “AM BP1” is selected.
AM BP1(.AM BP2 (BP=Beat Proof)
	TUNED

FM frequency step

Main unit only

The step is factory-set to 0.2-MHz (200-kHz), but you can change it to receive broadcasts allocated in 0.1-MHz (100-kHz) steps.

1Press [SELECTOR] to select “FM”.

2 Press and hold [SELECTOR].

After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed.

To return to the original step, repeat steps 1 and 2.

After changing the setting, previously preset frequencies will be cleared. Preset them again.