Panasonic SC-HC3 Preparing the remote control, Demo function, Connections continued, 3030

Connections (continued)

Optional antenna connections

FM outdoor antenna	AM outdoor antenna
FM outdoor antenna (not included)	AM outdoor antenna (not included)

	1	5 to 12 m
		(16 to 40 ft.)
2
		3

	AM loop antenna
75 Ω coaxial cable (not included)	(included)

•Never use an outdoor antenna during a lightning storm.

•You can connect the FM outdoor antenna for better reception. Please consult your dealer for installation.

•Disconnect the FM indoor antenna if an FM outdoor antenna is installed.

•Connect the AM outdoor antenna without removing the AM loop antenna. Run 5 to 12 m (16 to 40 feet) of vinyl-covered wire horizontally along a window or other convenient location.

Preparing the remote control

R6/LR6, AA

Place this side in before the other side

■Batteries

•Use a manganese dry battery or an alkaline dry battery.

•Insert so the poles (+ and – ) match those in the remote control.

•Remove if the remote control is not going to be used for a long period of time.

•Store in a cool, dark place.

•Do not heat or expose to flame.

•Do not leave the batteries in an automobile exposed to direct sunlight for a long period of time with doors and windows closed.

•Mishandling of batteries in the remote control can cause electrolyte leakage, which may cause a fire.

Do not:

•mix old and new batteries;

•use different types of batteries at the same time;

•take apart or short-circuit;

•attempt to recharge alkaline or manganese batteries;

•use batteries if their covering has been peeled off.

Remote control signal sensor

30°30°

Transmission window

■Use

•Aim at the sensor, avoiding obstacles, at a maximum range of 7 m

(23 feet) directly in front of the unit (Exact distance depends on angles).

•Operation can be affected by strong light sources, such as direct sunlight, and the glass doors on cabinets.

Demo function

Top View (Top Panel)

POWER

DEMO

[g, –DEMO]

When the unit is first plugged in, a demonstration of its functions may be shown on the display.

If the demo setting is off, you can show a demonstration by selecting “DEMO ON”.

Press and hold [g, –DEMO].

The display changes each time the button is held down.

DEMO OFF DEMO ON

RQTX0250

5

While in standby mode, select “DEMO OFF” to reduce power consumption.