Panasonic SC-HT67 warranty Simple setup, Speaker cords, About, 10 cm, Notes on speaker use

Speaker cords

Attach the stickers to the speaker cords.

≥Attach the numbered stickers to the end of the speaker

cords so the numbers match the positions of the speak-

ers shown in the diagram.							About
							10 cm
								(4")
6	5	4	3	2	1	1
6	5	4	3	2	1
						L FRONT
						FRONT L		FRONT L
6	5	4	3	2	1
6	5	4	3	2	1	1		1

Twist the vinyl tip and pull off.

1 3

2

Simple setup

Red Gray

≥Connect the cords to the terminals of same color so the num- bers on the stickers match the numbers under the terminals.

≥Never short-circuit positive (i) and negative (j) speaker wires. ≥Be sure to connect only positive (red or gray) wires to positive (i) terminals and negative (black or gray with blue stripe) wires

to negative (j) terminals.

Incorrect connection can damage the speakers.Black ≥After you have completed setup and connection, wind the ex-

cess cord and keep together with string. ≥The speaker nets cannot be removed.

Notes on speaker use

≥You can damage your speakers and shorten their useful life if you play sound at high levels over extended periods.

6	5	4	3	2	1
		R
			L	R
	CENTER				L
	SUBWOOFER		SURROUND		FRONT

SURROUND R

+ Gray (no stripe) - Gray with blue stripe

Blue

		FRONT L
	FRONT R	1	Front speaker (left)
SURROUND L	2	Front speaker (right)
3	Surround speaker (left)

Reduce the volume in the following cases to avoid damage.

–When playing distorted sound.

+ Red - Black

CENTER	4	Surround speaker (right)
5	Center speaker

–When the speakers are receiving howling from a micro- phone or record player, noise from FM broadcasts, or con- tinuous signals from an oscillator, test disc, or electronic instrument.

–When adjusting the sound quality.

–When turning the unit on or off.

SUBWOOFER
6	Subwoofer

Attaching to a wall

Front and surround speakers can be attached to a wall.

Atttach four speaker feet to each speaker, ensuring they do not cover the holes.

Set the speaker onto screws and slide through bracket to lock

into position.

Speaker feet (included)

Screw (not included)

Speaker feet (included)

Attaching to speaker stands

Ensure the following conditions are met when you purchase your speaker stands.

≥Observe the diameter and length of the screws and the distance between screws as shown in the diagram.

≥The stands must be able to support over 5 kg (11 lb.).

≥The stands must be stable even if the speakers are in a high position.

5 mm (13⁄64q),
pitch 0.8 mm	60 mm (223⁄64q)
(1⁄32q)

30–35 mm

(13⁄16q–13⁄8q)

Ø7.5–9.5 mm

(19⁄64q–3⁄8q)

7–9 mm

(9⁄32q–23⁄64q)

Note

The wall or pillar on which the speakers are to be attached should be capable of supporting 5 kg (11 Ib.) per screw.

Attach the stands with these holes.

Plate thickness plus 7 to 10 mm (plus 9⁄32q to 25⁄64q)

Speaker stand (not included)

7

RQT6191