Simple setup | Make sure you have all the indicated components before starting assembly, setup, and | ||||
| |||||
STEP1 | connection. |
| 2 front and | 4 large washer 4 mounting plates | |
4 bases | 4 pipes | ||||
2 surround | screws | ||||
|
| speaker units |
| ||
|
|
| 8 small screws | ||
|
|
|
| ||
Front and surround speaker assembly
[Note]
The front and surround speaker pairs as well as the pipe pairs are different.
–Check the label on the rear of the speaker before attaching the pipe (‹page 6).
–The pipe with the shorter cable is for the front speaker unit.
Preparation
≥To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥For assembly, use a
2Attach plate A to the speaker.
Ensure that plate A is fastened on straight by lightly tightening the top and bottom screws alternately until fully tightened.
Small screws
Speaker
Plate A
Polyfoam
Front and surround speaker assembly
RQT7436
4
1 Attach the pipe to the base.
1Thread the speaker cable through the base.
Lessen excess speaker cable.
| Thread the | |
Cable | speaker cable | |
through here. | ||
| ||
| Hole for screw |
Groove
2Insert the pipe.
Insert the pipe while gently pulling on the speaker cable.
3Secure the pipe to the
base. | Rear side of base | |
| ||
Ensure the screw is | Large | |
securely fastened. | washer | |
screw | ||
| ||
| Cable |
The supplied stands are specially designed for attachment to Panasonic
2 Attach the stands to the front and surround speakers.
≥There is no difference between the right and left speakers and stands. ≥Using the polyfoam included with this unit may be convenient.
1 Remove the screw and separate the mounting plate into two parts.
Plate B Plate A
Small screw
You can also attach to the upper rear of the speaker.
The height of the speaker is indicated in the diagram
(‹ page 5) when attaching plate A to the upper rear or lower rear of the speaker.
3Place the pipe on plate A and attach plate B.
Plate B | Rotate the pipe so that the flat |
| side is facing away from the |
| back of the speaker. |
Fit the offset into the slot and slide plate B into the locked position.
Plate B
Offset
Slot
4Secure the plate with the same screw removed in procedure 1.
Small screw
