Panasonic Official Manual for the SA VK91D Stereo System

The radio

		BAND
		TUNER
, REW/
,	/FF
PROGRAM		Numbered
PLAY MODE
		buttons
TUNER/AUX
operations
Radio	SKIP

Manual tuning

1Press [TUNER/AUX] (main unit: [BAND, TUNER]) to select “FM” or “AM”.

The unit comes on.

Every time you press the button: FM → AM → AUX

2Press [(] or [)] (main unit: [g, REW/4] or [f, 3/FF]) to select the frequency.

Press and hold [(] or [)] (main unit: [g, REW/4] or [f, 3/FF]) until the frequency starts scrolling to start automatic tuning. Tuning stops when a station is found.

“TUNED” is displayed when a radio station is tuned.

“ST” is displayed when a stereo FM broadcast is being received.

LIf noise is excessive in FM

Press [PLAY MODE] to display “MONO”.

Monaural sound is selected and noise reduces when reception is weak.

Press [PLAY MODE] again to cancel the mode. “MONO” is also canceled if the frequency is changed.

LAM allocation setting (main unit only)

For Saudi Arabia, Kuwait, the Middle East, South Africa and Southeast Asia

The step is factory-set to 9 kHz, but you can change it to receive

broadcasts allocated to 10 kHz steps.

1.Select “FM”.

2.Press and hold [BAND, TUNER].

After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed.

To return to the original step, repeat the above steps.

Note

After changing the “allocation” setting, the frequencies you previously

preset in the memory will be cleared. Preset them again.

Preset tuning

There are two methods of pre-setting stations.

Automatic presetting :All the stations the tuner can receive are preset.

Manual presetting :You can select the stations to preset and the order they are preset in.

Up to 15 stations each can be set in the FM and AM bands.

Preparation:

Press [TUNER/AUX] (main unit: [BAND, TUNER]) to select “FM” or “AM”.

Automatic presetting

Do the following once each for FM and AM.

Preparation: Tune to the frequency where pre-setting is to begin.

Press and hold [PROGRAM] until the frequency changes.

The tuner presets all the stations it can receive into the channels in

ascending order.

•“SET OK” is displayed when the stations are set. The last station to be set is then played.

“ERROR” is displayed

Presetting was unsuccessful. Preset manually.

Manual presetting

Pre-set the stations one at a time.

1Tune to the station (A see left).

2Press [PROGRAM].

3While “PGM” is flashing on the display

Press the numbered buttons to select a channel.

Alternatively, press [g, 4] or [f, 3] (main unit:

[g, REW/4] or [f, 3/FF]) then press [PROGRAM].

The station occupying a channel is erased if another station is preset in that channel.

Selecting channels

1Press [TUNER/AUX] (main unit: [BAND, TUNER] to select “FM” or “AM”.

2Press the numbered buttons or [g, 4] or [f, 3] to select the channel.

RQT7700