Panasonic SC-VKX25 Specifications, Remote control code, System memory reset, █To set the code to “REMOTE 2”, █To set the code to “REMOTE 1”, █Amplifier section, █ USB section

When other Panasonic equipment responds to the remote control of this system, change the remote control code for this system.

Preparation

Press [RADIO/AUX] to select “AUX 1” or “AUX 2”.

1 Press and hold [RADIO/AUX] on the main unit and [2] on the remote control until “REMOTE 2” is shown.

2 Press and hold [OK] and [2] for a minimum of

4seconds.

1 Press and hold [RADIO/AUX] on the main unit and [1] on the remote control until “REMOTE 1” is shown.

2 Press and hold [OK] and [1] for a minimum of 4 seconds.

Note:

After you set the code, you can continue to use the TV operation buttons on the remote control to operate a Panasonic TV (Z 9).

Reset the memory when the following situations occur:

•There is no response when buttons are pressed.

•You want to clear and reset the memory contents.

1 Disconnect the AC mains lead.

2 While you press and hold [1] on the main unit, connect the AC mains lead again.

Continue to press and hold the button until “– – – – – – – –” is shown.

3 Release [1].

All the settings are set back to the factory preset. It is necessary to set the memory items again.

Preset station	FM 30 stations
	AM 15 stations

Frequency modulation (FM)

Frequency range

87.50 MHz to 108.00 MHz (50 kHz step)

Antenna terminals75 (unbalanced) Amplitude modulation (AM)

Frequency range

522 kHz to 1629 kHz (9 kHz step)
520 kHz to 1630 kHz (10 kHz step)
AUX 1
Audio input	Pin jack (1 system)
AUX 2
Sensitivity	100 mV, 4.7 k
█ USB section
USB port
USB standard	USB 2.0 full speed
Media file format support	MP3 (*.mp3)
USB AUDIO	MP3 (*.mp3)
USB VIDEO JPEG (.jpg, .jpeg), Xvid (.xvid, .avi)
USB device file system	FAT12, FAT16, FAT32
USB port power	500 mA (max)
Bit rate	Up to 4 Mbps (Xvid)
USB recording
Bit rate	128 kbps
USB recording speed	1x
Recording file format	MP3 (*.mp3)

RQT9952