5.Perform the read power adjustment. Set the light power at 600 
W ±10% by using VOL+,
1 step.
Caution:
Proceeding on to the subsequent adjustment procedure with the read power exceeding 600 
W±10% will result in damage to the optical pickup.
6.Press the 
key of the remote controller (“LP ” changes to “RLDA ” in the LCD).
Specified range (read power): 600 
W±10% or lower
7.Perfome the light power adjustment. Set the light power at 5.7mW by using VOL+,
Specified range (light power): 5.7mW
Caution:
Do not allow the write power to even momentarily reach or exceed 6 mW. Doing so will result in damage to the optical pickup.
8.Press the 
key of the remote controller (“RLDA ” changes to “LP ” on the LDC. At this time, the data is written to EEPROM.).
9.Press the PLAY key on the remote controller (“LP ” changes to “T0E** ” on the LCD.).
10.Remove the laser power meter. Laser power adjustment is finished.
6.2.3.
1.After laser power adjustment performed, press the 
key of the remote controller and make “T1E** ” display on the LCD .
2.Make the optical pickup move to center.
3.Press the PLAY key of remote controller without insert disc (change the display of the LCD to “0FADJ ” , adjustment will be started.).
