Panasonic SL-DZ1200 Inserting-removinga disc or SD Memory Card, Inserting a disc, Removing a disc

Inserting-removing a disc or SD Memory Card

Basic operations

Rear panel

Front panel

Power lamp

With the label face up

Inserting a disc

1.Press [POWER OFF ON] on the rear of unit

The unit power is on. The display comes on and the power lamp lights.

2.Insert a disc

•Insert the disc flat and parallel into the CD slot, with the label up. The unit will automatically load the disc.

•You cannot use an 8 cm disc.

Note

•Do not insert a disc when the power is off.

•Do not insert 2 or more discs.

•Do not try to insert the disc using unnecessary force that may bend the disc. When the unit is loading or ejecting a disc, do not apply opposing force to the disc. Not following the above steps may re- sult in damage to the disc or unit.

Removing a disc

While stopped or while paused

Front panel

SD ACCESS

indicator

With the label face up

SD Memory Card

Inserting a SD Memory Card

1.Open the SD Memory Card slot lid

2.With the label on the card facing up and the notched edge facing the unit, insert the card

3.Insert until the card locks into place

4.Close the lid

Removing a SD Memory Card

After confirming the SD ACCESS indicator is not flash- ing, open the lid and press on the center of the SD Memory Card to release the lock and pull the ejected card out carefully, then close the lid.

•The SD ACCESS indicator flashes when the SD Memory Card is being accessed. Do not turn off the power or try to open the lid and remove the card while the indicator is flashing. (Doing so may result in a loss of saved data.)

Note

•Make sure to always close the SD card slot lid.

If you try using when the lid is open, “NO SD CARD” or “SD LID OPEN” will appear in the display and operation will not be pos- sible.

1. Press [ CD EJECT]

•Press the button and the disc will come out.

•If you press while playing in TURNTABLE mode, a message ap- pears in the display and play continues. Make sure to press af- ter pausing play.

•If you do not remove the disc within approximately 10 seconds the unit will automatically re-load the disc.

To remove

2. Press again

•Remove as indicated in the illustration without touching the playing surface.

Forced disc eject

You can forcefully eject a disc when the disc does not eject even after pressing [ CD EJECT].

	Playable media	Reference
		Page
		25
CD	CD-DA audio that is finalized on a
	CD-R or CD-RW
		12, 22
	MP3 files
	(WMA is not supported)
SD Memory Card	Secure AAC
	Secure MP3	22
(SD audio)
	(WMA is not supported)

1. Press [POWER		OFF	ON] to turn the power off
2. Press [POWER		OFF	ON] again holding down
[	CD EJECT] to turn the power on, and then release
[	CD EJECT] after “DZ1200” appears in the display

10

RQT7114