Panasonic TC-P54V10, TC-P50V10 quick start Select Connection test and press OK

Check that the network settings are as shown below, and then start “Connection test”.

Select “Connection test” and press OK.

*Press OK again to cancel the test. (It takes a while to cancel the test.)

Network setting	1/2	select
Connection test	Succeeded
IP setting mode	Manual	ok
IP address	192.168.0.5
Subnet mask	255.255.255.0
Default gateway	192.168.0.254

Succeeded: “Connection test” succeeded Only home network:

Home network is available.

Failed: Check the broadband environment connection and settings and the network settings, and then perform the test again.

Test in progress

---: Test not yet performed

Select “IP setting mode” and set to “Automatic”.

(When IP automatic acquisition in DHCP can be used)

Network setting		1/2	select
Connection test	Succeeded
IP setting mode	Automatic
IP address	192.168.0.5		ok
Subnet mask	255.255.255.0
Default gateway	192.168.0.254

■Manual setting

Select “IP setting mode” and set to “Manual”

Select the item and press OK

Check the specifications of the broadband router and enter each IP address.

Subnet mask 0 . 0 . 0 . 0

The acquired address is displayed.

Each IP address is acquired automatically.	or	change
		channel
		ok

Network

Select “DNS setting mode” and set to “Automatic”.

(When DNS automatic acquisition in DHCP can be used)

Network setting	1/2	select
Connection test	Succeeded
Default gateway	192.168.0.254
DNS setting mode	Automatic
	Automatic	ok
Primary DNS	192.168.0.20
Secondary DNS	192.168.0.21

The acquired address is displayed.

■Manual setting

Select “DNS setting mode” and set to “Manual”

Select the item and press OK

Enter each IP address as was specified by the provider.

Primary DNS 0 . 0 . 0 . 0

Setting

Each IP address is acquired automatically.	or	select
If you are using a broadband router, IP automatic		ok
acquisition in DHCP can be used under normal
circumstances. If you are not sure, check with the
person who installed the equipment, or check the
instructions for each device.

Advanced

Select “LAN speed setting” (Default is “Automatic”)

		select
Network setting	2/2
LAN speed setting	Automatic
LAN speed	10BASE half duplex
Software update		adjust
MAC address	12-34-56-78-80-ab

Normally, select “Automatic”.

If “Connection test” failed, set the “LAN speed setting” to “manual” and then select “10BASE half duplex”, “10BASE duplex”, “100BASE half duplex” or “100 BASE duplex”.

Cannot be selected when the “LAN speed setting” is “Automatic”.

Changing the settings may make it impossible to connect some types of equipment.

Select “Software update”			Press OK to start the software update screen.
		select	Follow directions of the screen.
Network setting	2/2
LAN speed setting	Automatic		* Set “Clock” first. (p. 18)
LAN speed	10BASE half duplex
Software update		ok
MAC address	12-34-56-78-80-ab

The network settings become effective when you close the menu and run “Connection test”.

45