Panasonic TH-103PF10UK manual During Multi PIP Operations, Normal Full, Picture Explanation

ASPECT Controls

The Plasma Display will allow you to enjoy viewing the picture at its maximum size, including wide screen cinema format picture.

Press repeatedly to move through the aspect options:

NORMAL ZOOM FULL

[from the unit]

Right side surface

ENTER/

+ /

VOL

- /

Panasonic AUTO JUST

Note:

When selecting an input slot that attaches BNC Dual Video Terminal Board (TY-FB9BD), Panasonic AUTO cannot be selected.

The aspect mode changes each time the ENTER button is pressed.

[During MULTI PIP Operations]			NORMAL	FULL
•	Picture and Picture, Picture in Picture	:
•	Others	:	Aspect switching is not possible.

Notes:

• For PC signal input, the mode switches between “NORMAL”, “ZOOM” and “FULL” only.

•For a 1125 (1080) / 60i · 50i · 60p · 50p · 24p · 25p · 30p · 24sF, 1250 (1080) / 50i, 750 (720) / 60p · 50p signal input, the mode is set to “FULL” mode, and switching is not possible.

•Panasonic AUTO can be selected only during Video signal input.

•The aspect mode is memorized separately for each input terminal.

Mode	Picture		Explanation
	4		NORMAL will display a 4:3 picture at its standard 4:3 size.
	NORMAL
NORMAL	3
	4	16	ZOOM mode magnifies the central section of the picture.
		ZOOM
ZOOM	3	9
	4	16	FULL will display the picture at its maximum size but with slight
		FULL	elongation.
FULL	3	9
	4	16	JUST mode will display a 4:3 picture at its maximum size but with aspect
		JUST	correction applied to the center of the screen so that elongation is only
JUST	3	9	apparent at the left and right edges of the screen. The size of the picture
			will depend on the original signal.
	4	16	The display will automatically become enlarged (depending on the
		Panasonic AUTO	picture source), allowing you to view the picture at its maximum size.
	3	9	Notes:
			• Panasonic AUTO mode is designed to automatically adjust the aspect
	For an elongated image	Image is expanded	ratio to handle a mix of 16:9 and 4:3 program material. Certain 4:3
Panasonic			program material, such as stock market data screens, may occasionally
			cause the image size to change unexpectedly. When viewing such
AUTO		Changes in
	4		programs, it is recommended that the ASPECT be set to NORMAL.
		accordance with the	• If adjusting the PICTURE V-POS/V-SIZE in Panasonic AUTO with FULL
	3	Panasonic AUTO	mode, the adjustment is not memorized. When exiting the mode, the
		mode setting (see	screen will return to a former adjustment.
		page 42).
			• Panasonic AUTO can not be selected while BNC Dual Video Terminal
	For a 4:3 image
			Board (TY-FB9BD) is installed.

Note: Do not allow the picture to be displayed in NORMAL mode for an extended period, as this can cause a permanent image retention to remain on the Plasma Display Panel.

19