Adjusting POS. /SIZE

H-POS

Adjust the horizontal position.

V-POS

Adjust the vertical position.

 

 

 

 

 

 

 

H-SIZE

Adjust the horizontal size.

V-SIZE

Adjust the vertical size.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CLOCK(PC IN terminal (when “COMPONENT/RGB-IN SELECT” is set to “RGB”))
PHASE

Eliminate the flickering and distortion.

DOT

(PC IN terminal (when “COMPONENT/RGB-IN SELECT” is set to “RGB”))

CLOCK

Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,

 

adjust so that any such noise is minimized.

OVER

Turn image over scan ON/OFF.

SCAN

Configurable signals are as follows:

 

525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, DVI, HDMI)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ONOFF

Notes:

•“OFF” is effective during only “FULL” aspect mode.

•When “OFF” is set, “H-SIZE” and “V-SIZE” cannot be adjusted.

1:1 PIXEL Adjusts the display size when 1125i or 1125p signal is input.

MODE

Notes:

•“ON” is effective during only “FULL” aspect mode.

•Select ON when you would like to replay 1920 × 1080 input signal.

•Applicable input signal;

1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p

•Select OFF when flickering is shown around the image.

•H-SIZE and V-SIZE cannot be adjusted when ON is selected.

OFFON

Helpful Hint ( / NORMALIZE Normalization)

While the POS. /SIZE display is active, if either the N button on the remote control is pressed at any time or the ACTION () button is pressed during “NORMALIZE”, then all adjustment values (except “CLOCK PHASE” and “DOT CLOCK”) are returned to the factory settings.

23