Connections
How to connect the PC Input Terminals
COMPUTER
AUDIO
PC IN
| Conversion adapter (if necessary) | ||
| RGB |
| |
|
|
| |
| PC cable |
| |
| Ferrite core | Less than |
|
| (supplied) |
| |
| 7" 7/8 |
| |
|
| (20 cm) |
|
| Audio |
|
|
|
|
| 1/8" (3mm) stereo plug |
| Connect a cable which matches |
| |
| the audio output terminal on the computer. |
| |
Installing the ferrite core |
|
|
|
1 | 2 | 3 |
|
| Open |
|
|
Pull back the tabs | Press the cable | |
through and close | ||
(in two places) | ||
|
Notes:
(1)Computer signals which can be input are those with a horizontal scanning frequency of 15.5 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, signals cannot be displayed if signals exceeding 1200 lines will not be displayed properly.)
(2)The display resolution is a maximum 640 ⋅ 480 dots when the aspect mode is set to “4:3”, and 852 ⋅ 480 dots when the aspect mode is set to “16:9”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
(3)The PC input terminals are
(4)Some PC models cannot be connected to the set.
(5)There is no need to use an adapter for computers with DOS/V compatible
(6)The computer shown in the illustration is for example purposes only.
(7)Additional equipment and cables shown are not supplied with this set.
(8)Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified frequency range.
Signal Names for D-sub 15P Connector
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
Pin Layout for PC Input Terminal
Pin No. Signal Name
1R
2G
3B
4GND (Ground)
5GND (Ground)
Pin No. | Signal Name | Pin No. |
6 | GND (Ground) | 11 |
7 | GND (Ground) | 12 |
8 | GND (Ground) | 13 |
9 | NC (not connected) | 14 |
10 | GND (Ground) | 15 |
Signal Name
GND (Ground)
SDA
HD/SYNC
VD
SCL
13
