Panasonic TX-76DT30A manual VCR Installation, Str

VCR Installation

Your new TV is supplied with programme position '0' set to receive an RF signal from your VCR, although an AV connection is preferable. Please refer to page 40 for AV connections.

However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or sound from your VCR on programme position '0' of the TV. It will be necessary to either adjust the RF channel of your VCR (some VCR's allow adjustment of their RF channel via their remote control unit) or to adjust the tuning of the TV's programme position '0' or both until it receives the RF output channel of your VCR.

It is intended that this advice be used in conjunction with the instruction books for your additional equipment

Use the AV2 Scart terminal for a standard VCR or an S-Video VCR or a Q-Link (or compatible) VCR.

To tune your TV to the VCR

Switch on the VCR, Insert and play a pre-recorded tape with known content

On the TV, select programme position '0'

Open the Front panel flap.

Press the F button repeatedly until 'Tuning mode" is reached.

Press the - or + button to access Tuning mode.

Press - or + to begin searching for the VCR playback.

F

- / \/ - / \/

- / \/ - / \/

MANUAL TUNE (FRONT PANEL)

- , +		:	Search
	TV/AV	:	Move cursor
	STR	:	To store
	F	:	To exit
21			68

STR F -/\/ +//\ TV/AV

When the VCR playback Is found, press	STR
the STR button to store the programme
position

The programme position and channel number indicators will flash to indicate the station is being stored.

To exit Manual Tuning, press the F button.

Note:

If picture patterning occurs on programme position '0' it may be necessary to adjust the RF output Channel of the VCR, refer to your VCR instruction book.

36