Panasonic TY-WK5P1SW manual Components, Parts used for installation

Components	[The images shown in this manual are for illustrative
	purpose only.]

TY-WK5P1SWWall-hanging bracket (Vertical mounting type)

Parts used to assemble the wall-hanging bracket

 Base upper and lower		 Bracket base left fitting	 Bracket base right fitting	 M5x10 screws for
fittings	(2)	(1)	(1)	assembling the
				fixture	(4)

English

Parts used for installation

View of fully assembled fixtur

M8×24 Allen head	Positioning stickers	(2)
countersunk screws	(4)

Dished toothed washers	(4)	Long bolt for securing the unit	(1)
		Screw M6 x 50 for securing
		the unit	(1)
Insulation spacers	(4)

Allen wrench (included tool) (1)

Please note the following before proceeding with installation:

ƇThe plasma TV unit which will be attached to the wall-hanging bracket consists of the display unit, tuner unit and speakers.

Precautions for wall-hanging bracket fitting

ƇThe wall-hanging bracket is for use in attaching a plasma TV unit to a vertical wall for viewing. Do not fit to any surface other than a vertical wall.

ƇTo ensure correct plasma TV performance and prevent trouble, do not fit at any of the following locations.

•Near sprinklers or fire/smoke detectors

•Where there is a risk of exposure to vibration or impact

•Near high-voltage wires or dynamic power supplies

•Near sources of magnetism, heat, water vapor or soot

•Locations exposed to air blown from heating equipment

•Where droplets of condensation from an air conditioner or other unit may form.

ƇFit using techniques suited to the structure and materials of the fitting location.

ƇUse commercially available screws with a nominal diameter of 6 mm (0.2 inches) that are suited to the wall material (wood, steel frame, concrete etc.) you are fitting the bracket to.

ƇFor the TV power supply plug, use a power supply outlet that can be reached easily.

ƇEnsure good air flow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to do this may cause heat to build up inside the plasma TV, resulting in malfunction.

ƇSpread a soft blanket or cloth over the floor so that the plasma TV and floor will not be marked or scratched during the assembly and installation work.

ƇWhen screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened.

ƇTake sufficient care to ensure safety around you when performing the assembly and installation work or while moving about during the course of the work.

ƇDo not install the Plasma TV underneath ceiling lamps (spotlights, halogen lamps, etc.). Otherwise, the cabinet may be bent or damaged by high heat.

3