Panasonic TY-WK5P1SW manual Fitting procedure, Assembling the wall- hanging bracket

English

Fitting procedure	[Never use any other method than specified to
	install.]

1.Assembling the wall- hanging bracket

1. Remove the screws for securing the bracket base left and right fittings.

2.Lay the base upper and lower fittings and the bracket base left and right fittings

and as shown in the figure.

3.Fit the tabs of the bracket base left and right fittings into the cutouts of the base

upper and lower fittings above, and secure them using the two screws used to assemble the bracket.

(Tightening torque: 1.2 to 1.5 N•m)

4.Open slightly the bottom of the bracket base left and right fittings, and fit their tabs into the cutouts of the base upper and lower fittings, and secure them using

the two screws used to assemble the bracket.

(Tightening torque: 1.2 to 1.5 N•m)

5. Tighten the screws for securing the bracket base left and right fittings which were loosen in step 1.

Inside	: 46-inch model
Outside	: 50 or 54-inch
Screw for securing the	model
bracket base fitting
Base upper and lower fittings
Bracket base left
fitting

Tab

Cutout

Bracket base

right fitting M5x10 screws for assembling the fixture

Base upper and lower fittings

Note

•Please hold the bracket base left and right fittings as you work with the assembled wall hanging bracket. Holding the base upper and lower fittings might deform this unit.

2.Checking the strength of the installation location

1.The wall-hanging bracket weighs approximately 2.3 kg (5.1 lbs).

Refer to the instruction manual of the plasma TV, and check the weight of the plasma TV unit which will be fitted into the wall-hanging bracket.

2.Refer to the outline drawing of the wall-hanging bracket shown on the right, and check the wall strength at the six installation positions shown. If the strength at any of these positions is lacking, provide sufficient reinforcement.

Notes

•There are five pre-drilled mounting holes at the top and another five at the bottom of the wall-hanging bracket.

Use the spare holes provided if wood or some other material is used for the wall and a sufficient level of mounting strength cannot be ensured by anchoring the fixture at the six positions shown on the right.

However, bear in mind that, depending on which materials the mounting surface is made of, cracks may form on the surface if the screws are used at positions which are too close together.

•Mount or place only a plasma TV on the fixture: Do not mount or place any other product.

•For details on the dimensions applying when the plasma TV is mounted, refer to the outline drawing (See back cover).

				Unit: mm (inches)
			600 (23.6)
		80	440	80
17.5	(0.7)	(3.1)	(17.3)	(3.1)
325	(12.8)
59.5	(2.3)	42		42
		(1.7)	516 (20.3)	(1.7)

Wall mounting holes (at 6 points)

Use the screws without fail to anchor the fixture.

4