Panasonic TY-WK5P1SW manual How to remove the plasma TV from the wall-hanging bracket

4. Tighten up the long bolt for securing the unit , which was secured loosely in step 5 of section 3, until it will go no further.

Note

• Tightening up the long bolt for securing the unit or the screw for securing the unit too much may cause the bracket to be bent out of shape.

5.Lift the display unit slightly, and check that it is firmly secured in place.

6.Connect the HDMI cable to the tuner unit.

4. Long bolt for securing the unit

English

How to remove the plasma TV from the wall-hanging bracket

1. Remove the long bolt for securing the unit or the screw for securing the unit which is attached to the side of the wall-hanging bracket.

2.Disconnect the wires connecting the plasma TV to the other units.

3.While lifting the bottom part of the plasma TV, pull the plasma TV toward you.

4.Once the insulation spacers at the bottom have been released, lift the plasma TV straight up.

5.Ensure that the plasma TV unit, which has now been removed from the wall-hanging bracket, is kept upright while it is being handled so that no load will be applied to its front or back panel.

	4.
Surface of wall	Surface of wall
	3.

Long bolt for securing

the unit

Insulation spacer at the bottom

7