3. Hang the elite Panaboard on the stand with the
screw heads.
4. Secure the elite Panaboard to the stand frame
using the two-wing bolts (M5 ´ 12 mm [1/2 in.]
[2 count]) included with the stand.
Note
•After installation is complete, use the
included cable holder to manage the power
cord and USB cable.
•When installing the elite Panaboard on the
stand, you can adjust its height to 4 different
levels.
When changing the height, remove the left
and right screws from the back of the elite
Panaboard, and securely insert them at the
desired height. Torque (greater than 1 N·m
[10 kgf·cm (9 lbf·in.)]).
elite Panaboard
Height Screw Position
-100 mm (-3 7/8 in.) Highest
Standard 2nd from top
+100 mm (+3 7/8 in.) 2nd from bottom
+200 mm (+7 7/8 in.) Lowest
5. Wipe the screen board surface.
Gently wipe the screen board surface with a soft,
moist cloth.
Notice
•Do not use thinner, benzene, or abrasive
chemicals to clean.
(Doing so can result in discoloration.)
•Do not wipe the screen board with a dry
cloth.
(Doing so can cause static electricity
build-up.)
6. Confirm that the elite Panaboard can operate.
See "Confirming the elite Panaboard
Operation" (page 57).
56 Operating Instructions (For Basic Operations)
Installation Manual