Warming Drawer (on some models)
Remove all items from inside the warming drawer, and allow the range to cool completely before attempting to remove the drawer.
To Remove:
1.Open drawer to its fully open position.
2.Locate the black
A
To Replace:
1.Align the drawer glides with the receiving guides.
2.Push drawer in all the way.
3.Gently open and close the drawer to ensure it is seated properly on the slides.
A.Tab
3.Press the tab down on the right side, and lift tab up on the left side at the same time, then pull drawer out another inch.
4.Holding the drawer by its sides, slowly pull it all the way out.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
■Is the power supply cord unplugged? Plug into a grounded outlet.
■Has a household fuse blown, or has a circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.
Cooktop will not operate
■Is the control knob set correctly? Push in knob before turning to a setting.
■On ceramic glass models, is the oven control lockout set? See “Oven Control Lockout” section.
Excessive heat around cookware on cooktop
■Is the cookware the proper size?
Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area.
Hot Surface indicator light stays on
■Does the Hot Surface indicator light stay on after control knob(s) have been turned off?
See “Cooktop Controls” section.
Cooktop cooking results not what expected
■Is the proper cookware being used? See “Cookware” section.
■Is the control knob set to the proper heat level? See “Cooktop Controls” section.
■Is the appliance level?
Level the appliance. See the Installation Instructions.
29
