Basic

Projecting

Adjusting the image manually

Check the connections of the peripheral devices and connection of the power cord (Æpage 29) and switch on the power (Æpage 31) to start the projector.

JJSelecting the image

Select an input signal.

The image selected with the <COMPUTER 1>, <COMPUTER 2>, <HDMI>, <VIDEO>, <S-VIDEO>, or <NETWORK> button is projected (Æpage 38).

Attention

zzImages may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Select a system format that is suitable for the input signal in [Component] or [RGB] in the [Input] menu (Æpage 43).

zzCheck the aspect ratio of the screen and the image and select the optimum aspect ratio under the [Screen] menu (Æpage 52).

JJAdjusting the state of the image

1111Adjust the projection angle

zzFor details, see “Adjusting front adjustable feet” (Æpage 27).

2222Adjust the zoom and the focus

Turn [Zoom lever] and [Focus ring] to adjust the image.

Adjusting the image automatically

Easy setting function makes the semi-automatically adjustment possible, so that to get the optimal image.

Auto setup function including these following functions (Æpage 56-57).

Input search Switching the input signal automatically.

Auto PC adj. The image projected from the computer automatically is optimal.

Focus assist The color of the bar assists the focus adjustment.

Detect and correct the image automatically to fit the frame. If

Screen fit you can not detect the frame of the screen, Keystone (standard) executes automatically.

The color values will change

Colorboard automatically to reach the optimal white balance according to the color

of screen.

JJAuto setup

When all of the above mentioned functions are set to [On], the adjustment orders are as follows.

Operation

Focus ring

Note

Zoom Lever

1111 Project an image.

2222 Adjust the zoom ring so that the image is larger than the screen frame.

3333 Press the <AUTO SET> button on the remote control or the <AUTO SETUP> button on the control panel during projection.

[Please wait ...] appears, Input search function starts to work and select an input signal.

If the input signal is an computer (analog) signal, Auto PC adj. function starts to work and get an optimal image.

Next, a test pattern for [Focus assist] appears on the screen and the focus assist bar appears in the center bottom of the screen.

zzIf you adjust the focus, you may need to adjust the size of the image by moving the zoom lever again.

zzIf keystone distortion occurs, see “KEYSTONE” (Æpage 53).

4444 Rotate the focus ring until the bar changes to blue and the image reaches to the maximum level.

34 - ENGLISH